Particles

This feature is only available from <%PRODUCERPROGRAMNAME_R_ORIG%> Premium.

Inserts additional images into the Particle object.

Removes selected images from the Particle object.

Under Direction you can set in which direction the particles disappear.

Directions:

0 degrees        = the particles move out of the image towards the right

90 degrees        = the particles move out of the image towards the bottom

180 degrees        = the particles move out of the image towards the left

270 degrees        = the particles move out of the image towards the top

You set the pace of the movement under speed. The higher the value is, the faster the particles fly over the screen. A value of 0 means no speed. The particles won't move.

Here you determine the size of the particles. The size will be calculated based on the size of the Position frome in Layout Designer. If the Position frame takes up the full in Layout Designer and Particle size  is set to 10% then the Particles will be 10% of the size of the Position frame. If you reduce the size of the latter the Particles become smaller, accordingly.

With the number of particles, you set the quantity of particles shown.

Here you can select an animation for the particles.

Here you set how strongly the movement should be carried out. The higher the number, the stronger.

The frequency specifies how often the movement is carried out. The smaller the number, the lower the number of movements.